Transmitters
Exit Wands
Keypads
Push Buttons
Electric Locks
Security Locks
Low Voltage Wires
Solar Panels

GTO 1 button transmitter
The GTO entry transmitter, with adjustable code settings is standard equipment with all GTO gate operator system. (battery included)
 

  GTO Exit Wand

Automatic Exit Sensor is an electromagnetic sensor that detects metal mass in motion providing a 12 foot radius of detection that allows hands free exit from automatic gateoperators. The sensitivity of the wand is adjustable for individual requirements.

GTO Keypad
The specially designed digital keypad can be easily installed as a wireless or wired keypad. It can be programmed to use up to fifteen different personal identification number (PIN) codes. Each code is face programmable with additional security features built in. Requires 3 AA batteries when used as wireless (not included).

GTO Wall Button
Unlit doorbell button for remote entry or exit control. Wires directly to the control board using 16 gauge, stranded low voltage wire (not included).
 

GTO Electric Lock
A MUST for added security. (for closed position pull-to-open applications) Driven by a 4 amp solenoid, the plated steel bolt lock has a zinc plate steel housing. The horizontal electric lock is used with all GTO swing gate operator systems for additional security and stability. Comes with a keyed manual release.
 

GTO Bulldog Pedestrian Gate Lock
Similar to the Automatic Gate Lock, but designed for horizontal use only on "walk-thru" gates without automatic operators. The Bulldog is an affordable solution to protecting swimming pool areas, playgrounds, tennis courts, boat docks, etc., from unwanted access. Includes control box and keyed manual release.
 

GTO Master Security Pin Lock
For Pro 1000,3000 & 4000 Series Gate Opener
The pin lock substitutes for the clevis pin at either of both mounting points of the GTO / PRO 1000 series operator arm. Helps prevent theft of the operator arm while allowing quick release of the operator.

 

Go to Online Store

GTO Low Voltage Wire (per ft.)
The 16 gauge, dual conductor, multi-stranded, direct burial, low voltage wire is required to connect the control board to either the solar paned ore the AC transformer. This wire is also required for installation of some accessories such as keypads, locks, or push buttons.



 

GTO 5 Watt Solar Panel
The solar panel is a solar powered battery charger for use with GTO Automatic Gate Opener Systems. Particularly suited for remote installations, the solar panel comes with tubular steel support, mounting clips, wire connectors, and 9ft. of low voltage wire. All operators are pre-wired for the solar panel. Installation in some regions of the world will require dual 5 watt panels or single 10 watt panel for adequate charging power.

GTO 10 Watt Solar Panel
The solar panel is a solar powered battery charger for use with GTO Automatic Gate Opener Systems. Particularly suited for remote installations, the solar panel comes with tubular steel support, mounting clips, wire connectors, and 9ft. of low voltage wire. All operators are pre-wired for the solar panel.